XROS 5: Screen shows "OVER TIME" and stops working
Written by Vape & E-Liquid Team Last updated
The screen displays "OVER TIME" and the device stops firing mid-draw or mid-button press. This is a built-in safety cut-off, not a fault.
Why this happens
- A single draw or button press lasted 8 seconds or longer, triggering the over-time protection cut-off
- Holding the fire button down continuously without releasing it, for example when passing the device to someone else or placing it in a pocket
- An auto-draw sensor picking up a prolonged, unintentional activation
How to fix it
- Release the draw or fire button immediately when you see "OVER TIME" on the screen
- Stop firing and wait a moment for the device to reset before taking another draw
- For future use, keep each draw or button press under 8 seconds to avoid triggering the cut-off again
- If the device does not respond after releasing and waiting, turn it off and back on using the power button
- If "OVER TIME" appears repeatedly during normal, short draws, check that the mouthpiece and pod are seated correctly and that nothing is blocking the airflow sensor, then contact Vaporesso support if the issue continues
Replacement pods and coils
Worn pods and coils cause most of these faults. We stock the parts that fit the XROS 5.
Other XROS 5 problems
- Burnt taste or dry hits Every puff tastes harsh, burnt or acrid, or the vapour feels dry and scratchy rather than smooth. This usually means the coil is not getting enough e-liquid before or during firing.
- Device not working or not firing You press the fire button and nothing happens, or the device powers on but refuses to produce any vapour. This covers a completely unresponsive device as well as one that appears on but will not fire.
- Not charging, stops charging, or charging animation explained The device is not charging when plugged in, the charging animation is not showing on screen, or the device stops charging before the battery is full.
- Screen shows "BATTERY LOW" and stops working The screen displays a BATTERY LOW message and the device cuts out, refusing to fire. This is the built-in low-voltage protection activating because the battery has discharged too far to operate safely.
- Screen shows "CHECK ATOMIZER" and device stops working The screen displays "CHECK ATOMIZER" and the device stops firing. This fault indicates the kit cannot detect a valid coil or pod connection.
- Screen shows "OVER HEAT" and stops working The screen displays "OVER HEAT" and the device stops firing. This is a built-in thermal protection cutting in because the device has detected a high internal temperature.
- Screen shows "SHORT ATOMIZER" and stops working The screen displays "SHORT ATOMIZER" and the device stops firing. This is a built-in protection response to a detected short-circuit or abnormally low resistance at the pod connection.
Related guides
What Wattage Should I Vape At? A Guide to Getting It Right
Wattage by coil resistance: what 0.2, 0.4, 0.6, 0.8 and 1.0 ohm coils want, pod vs tank coils, and why the printed range on your coil wins. Fix burnt or gurgling hits.
Read the guide
What Does Ohm Mean On A Vape? Resistance, Wattage & Coils Explained
What does ohm mean on a vape? Learn coil resistance, ideal wattage per ohm, sub-ohm vaping and MTL vs DTL, so you pick the right coil and e-liquid.
Read the guide