XLIM GO LITE

First use

Before your first vape, pull the pod out of the device and check the fill port is sealed. The rubber cap can be rotated slightly to make filling easier, so worth knowing before you crack the bottle open.

• To turn on: click the button 3 times rapidly. The LED will flash to confirm.
• To lock/unlock: click 4 times quickly. Useful if it's rattling around in a pocket.
• To vape: just draw. The Xlim Go Lite is draw-activated, no button hold needed.

Filling the pod

• Remove the pod from the device by pulling it free of the magnetic connector.
• Rotate and lift the rubber fill cap on the side of the pod.
• Insert your bottle nozzle into the fill port at an angle rather than pushing straight down onto the wick. This protects the cotton and reduces the risk of a dry, burnt first hit.
• Fill slowly until the liquid reaches the fill line. Don't overfill.
• Push the rubber cap firmly back into place until you feel it seat properly. If it's not fully closed, it will leak.
• Prime the coil - refit the pod and wait 5 minutes before your first draw. If you're impatient, take a few slow, gentle draws without activating the device to pull liquid into the coil first.

Liquid to use: The included 0.8Ω V3 pod is designed for MTL vaping. Pair it with a 50/50 or high-PG nic salt at 10mg or 20mg. High-VG shortfill in a tight MTL pod like this will wick slowly and cause dry hits.