SKE Bar 600
A rechargeable prefilled pod kit built for MTL vapers who want disposable-style simplicity without the waste, using swappable 2ml nic salt pods and USB-C charging.
Set up guide & tips
First Use
Remove the SKE Bar 600 from its packaging and peel off any stickers. Pull out the silicone plug from the base of the pre-installed pod before you take your first draw. Take two or three gentle puffs before vaping normally. This lets the mesh coil saturate properly and gives you a cleaner first hit.
The Bar 600 is inhale-activated, so there are no buttons to press during normal use. Just draw steadily and the device fires automatically.
Replacing a Pod
When your pod runs out, you will need to swap it rather than refill it. Pods are prefilled at the factory and are not designed to be topped up.
To remove a spent pod: press and hold both buttons on the front and back of the device simultaneously. The pod will release. Remove the silicone plug from your new replacement pod, then press it into the device until you feel and hear a click. Give it a couple of light test puffs before vaping normally.
Important: The SKE Bar 600 is only compatible with SKE Bar 600 prefilled replacement pods. Other SKE pod lines will not fit correctly.
Which Pods to Use
Because this is a prefilled system with a 1.2-ohm mesh coil, you are working with nic salt e-liquid rather than choosing your own. Replacement pods come in 20mg nic salt, which is the standard strength for this style of device and the maximum permitted under UK TPD regulations. Each pod holds 2ml, also the UK legal maximum for a single prefilled unit.
If you are stepping down from a higher-strength disposable, 20mg nic salts will feel familiar. If you find 20mg too strong, zero-nicotine versions of the replacement pods are available in a wide range of flavours.
Specifications
| Specification | Value |
|---|---|
| Capacity | 2ml |
| Battery Type | Built-In |
| Charging | USB Type-C |
| Resistance Range | 1.2Ω |
Frequently asked questions
Is the SKE Bar 600 the same as an Elf Bar 600?
No, they are separate products from different brands. Both are rechargeable 600-puff prefilled pod kits in a similar format, with USB-C charging and MTL draws, but they use different pods and are not cross-compatible. The SKE Bar 600 works exclusively with SKE Bar 600 replacement pods.
What pods fit the SKE Bar 600?
Only SKE Bar 600 prefilled pods are compatible with this device. The pods come in 20mg nic salt and zero-nicotine options across a wide flavour range. Do not attempt to use pods from other SKE lines or competing brands, as the connection and sizing differ.
How many puffs does each pod give?
Each pod is rated at approximately 600 puffs, but your actual count will depend on draw length. Longer, slower draws will reduce the total count. Shorter draws closer to a cigarette pull will get you nearer to the stated figure. Puff count is always an estimate rather than a guarantee.
Can I refill the SKE Bar 600 pods with my own e-liquid?
The pods are sealed prefilled units and are not designed to be refilled. Attempting to crack them open and top them up risks leaking and coil damage. When a pod is finished, replace it with a fresh SKE Bar 600 prefilled pod rather than trying to extend its life.
Does the SKE Bar 600 come with a charging cable?
No. The device charges via USB Type-C but a cable is not included in the box. Most USB-C cables will work, so if you have one for a phone or other device, that will do the job. If you need one, we stock USB-C charging cables separately.
How do I know when the battery needs charging?
The SKE Bar 600 does not have a detailed battery indicator. You will typically notice a weaker or shorter draw when the battery is low. Plug it in via USB-C and let it charge before the next session. Charging little and often is fine with this type of built-in cell.