Al Fakher Hypermax Prime 50K
A prefilled pod kit built around a snap-in dual pod system, designed for vapers who want long-lasting, low-maintenance vaping with a fresh coil every refill.
Set up guide & tips
What's in the box
Your kit includes the 1000mAh battery body, the Snap Dual pod module (with the mesh coil built inside), and two 10ml prefilled refill containers. Every refill pack you buy later includes a fresh pod module and two new containers, so the only thing you keep long-term is the battery.
First-time setup, step by step
- Remove the pod module and both refill containers from the packaging.
- Pull the small plastic plug from the bottom of each refill container.
- Snap the two refill containers into the Snap Dual pod module until they click into place.
- Remove the plastic clip from the side of the assembled module.
- Slide the assembled module onto the battery body until it clicks firmly.
- Press the mouthpiece down once to engage the system.
- Wait two to three minutes for the mesh coil to fully saturate before inhaling.
That waiting step matters. Skipping it and drawing immediately on a dry coil is the most common cause of a burnt or harsh first hit. Give the mesh time to wick properly.
Airflow adjustment
The adjustable airflow sits on the pod module. Close it down for a tighter, more cigarette-like MTL draw. Open it up for a looser RDL inhale with bigger vapour production. Most users who are switching from cigarettes find a partially closed setting closest to what they are used to.
E-liquid and nicotine
The refill containers come pre-filled with UK TPD compliant nic salt e-liquid, sealed at the factory. There is no filling step and no liquid to buy separately. Each container holds 10ml (20ml total per kit), which is the maximum permitted under UK TPD rules for prefilled pods. Nic salt at 20mg/ml gives a smooth throat hit even on higher-output draws, which suits the mesh coil setup well.
Replacing the pods
When both refill containers run dry, the entire pod module is replaced. Snap in a fresh pod module with two new refill containers from your next refill pack, press the mouthpiece to engage, and wait the usual two to three minutes before vaping. You get a new coil every single time, which is why flavour stays consistent across the life of each pod rather than degrading the way a reusable coil does.
On the 50,000 puff claim
Al Fakher's 50,000 puff figure is a maximum based on short, controlled draws. Real-world totals will be lower depending on your draw length, how open the airflow is, and how frequently you vape. Use it as a relative guide rather than an exact count.
Specifications
| Specification | Value |
|---|---|
| Capacity | 2 x 10ml refill containers (20ml total) |
| Battery Type | 1000mAh rechargeable |
| Charging | USB-C, Quick Charge 2.0 |
Frequently asked questions
What is the Al Fakher Hypermax Prime 50K?
The Hypermax Prime 50K is a rechargeable prefilled pod kit from Al Fakher's Crown Bar range. It uses a Snap Dual pod module with a built-in mesh coil and two 10ml prefilled refill containers. The 1000mAh battery charges via USB-C with Quick Charge 2.0. You keep the battery; the pod module and containers are replaced each refill.
How does the Snap Dual pod system work?
Two 10ml prefilled refill containers snap into a pod module that houses the mesh coil. That assembled unit slots onto the rechargeable battery. When the liquid runs out, you replace the whole module and both containers with a fresh set from a refill pack. This gives you a new coil every time, keeping draw quality consistent.
Is the Al Fakher Hypermax Prime 50K TPD compliant?
Yes. Each refill container holds 10ml and contains nic salt e-liquid at or below 20mg/ml, both within UK TPD limits. The total 20ml comes from two separate 10ml containers rather than a single oversized tank, which is how the system stays compliant while offering a higher liquid volume per kit.
How do I charge the Hypermax Prime 50K?
Charge via the USB-C port on the battery body. The kit supports Quick Charge 2.0, so charge times are faster than standard USB charging. The Silk Glow display lights up on every inhale to show your current battery level, so you can see when it is time to plug in.
Can I swap flavours on the Hypermax Prime 50K?
Yes. Refill packs are available across a wide range of flavours and each pack includes a fresh pod module plus two new refill containers. You pick a different flavour refill pack each time you reload. You cannot mix flavours within a single pod module, but swapping between packs is quick and straightforward.
How does the Hypermax Prime 50K differ from the Al Fakher 30K?
The key difference is where the coil lives. The 30K placed the coil inside the device body, so refill containers were liquid-only and the coil degraded over time. On the 50K, the coil is inside the pod module itself, meaning every refill pack delivers a fresh coil alongside fresh liquid, which maintains consistent flavour and draw throughout.