Voopoo Argus Z3

What's in the box

Your Argus Z3 arrives with the device, a 0.7ohm/1.0ohm Argus Multi-Ohm pod already fitted, a USB-C charging cable, and a user manual. Give the battery a full charge before your first session.

Charging

Plug in via the USB-C port at 5V/1A. A full charge takes around 70 minutes. The four-LED battery indicator shows charge level in 25% increments, so you can see at a glance when you're good to go.

Filling the pod

The Argus Multi-Ohm pod is top-filling. Remove the pod from the device by pulling it upward, then locate the silicone fill port on the top edge. Open it, fill slowly to avoid air pockets, and seal it back firmly before reinserting. The pod holds 2ml, which is the UK TPD maximum for a refillable cartridge.

Priming your coil

Voopoo haven't published specific priming steps for the Multi-Ohm pod, but the coil is built in rather than replaceable, so standard practice applies. Fill the pod, wait at least five minutes before your first puff, and start on a few gentle draws before vaping normally. This wicks the coil properly and helps avoid a dry, burnt first hit.

Choosing the right resistance

The Multi-Ohm pod switches between its two built-in coils simply by rotating the pod 180 degrees.

• 0.7ohm: slightly more vapour production, suits vapers who prefer a slightly more open MTL draw. The LED indicator shows blue when this coil is active.
• 1.0ohm: tighter, closer-to-cigarette draw with a smaller cloud. The LED shows green when active.

Both resistances deliver a mouth-to-lung inhale, so neither is a direct-to-lung setup.

Which e-liquid to use

Both coils pair best with a 50/50 (50% PG, 50% VG) or similar higher-PG e-liquid. Higher-VG shortfills are too thick for these pods and will cause wicking issues.

• 0.7ohm coil: 10mg to 20mg nic salt works well. If you're using freebase, 6mg to 12mg is a comfortable range.
• 1.0ohm coil: the tighter draw suits 10mg to 20mg nic salt particularly well, especially for people switching from cigarettes.

Keep nicotine within TPD limits of 20mg/ml maximum for any e-liquid bought in the UK.

Airflow

There is an adjustable airflow slider on the device. Close it down for a tighter, more cigarette-like draw, or open it slightly for a smoother, airier MTL. It makes a noticeable difference between the two coils, so it's worth experimenting when you swap resistance.

Compatible pods

The Z3 works with the full Argus pod family, covering resistances from 0.4ohm to 1.0ohm, including Argus, Argus Snap, and Argus Multi-Ohm pods.

Specification	Value
Size	113 x 27.6 x 16.6mm
Capacity	2ml UK TPD
Output Power	5W to 20W
Output Voltage	3.2V to 4.2V
Battery Type	1100mAh built in
Charging	Type-C, 5V and 1A
Resistance Range	0.4ohm to 3.0ohm