Vinci E80: Screen shows 'Atomizer Short'
Written by Vape & E-Liquid Team Last updated
The screen displays 'Atomizer Short' and the device stops firing. This is a protection alert telling you the mod has detected an electrical short in the coil or pod connection.
Why this happens
- Dirty or e-liquid-contaminated gold contact pins between the pod and mod, preventing a clean connection
- A stuck or non-flexible pin in the mod, stopping proper contact with the pod
- A faulty or shorted coil inside the pod
- E-liquid or condensate in the auto-draw sensor or mod cavity interfering with the connection
How to fix it
- Remove the pod from the mod and inspect the gold contact pins on both the pod base and the mod. If you can see e-liquid residue or condensate, clean them carefully with an alcohol-dampened cotton swab and allow them to dry fully before reassembling.
- While the pod is removed, gently check whether the pin inside the mod is flexible and springs back when pressed. A stuck, flat pin will not make proper contact with the pod. If the pin does not move at all, contact VOOPOO support or your retailer, as internal pin repair is not a user-serviceable task.
- Use an alcohol cotton swab to clean inside the auto-draw sensor area and the mod cavity, removing any e-liquid or condensate that may be causing the short alert.
- Rotate the pod 180 degrees and reinsert it, then try firing again. The manual notes that rotating the pod can improve the connection and is a standard first check.
- If the error persists, remove the current coil or pod and try a different coil or a replacement pod to determine whether the fault is with the coil or with the mod itself. If a new pod clears the error, the original coil or pod is faulty and should be replaced.
Other Vinci E80 problems
- Screen shows '20% Low Power' or battery is low The screen is displaying '20% Low Power', warning you the battery is running low. The device needs charging before the battery cuts out entirely.
- Screen shows 'Check Battery' The screen displays 'Check Battery' when you try to use the device. The device may not fire or may shut down shortly after the message appears.
- Screen shows 'Temp High' The screen displays 'Temp High' and the device stops firing. This is a built-in safety cut-off triggered when the internal temperature goes outside the safe operating range.
- Screen shows 'Time Out' and device stops firing The screen displays 'Time Out' and the device stops firing mid-use. This is a built-in safety cut-off, not a fault.
Related guides
What Wattage Should I Vape At? A Guide to Getting It Right
Wattage by coil resistance: what 0.2, 0.4, 0.6, 0.8 and 1.0 ohm coils want, pod vs tank coils, and why the printed range on your coil wins. Fix burnt or gurgling hits.
Read the guide
What Does Ohm Mean On A Vape? Resistance, Wattage & Coils Explained
What does ohm mean on a vape? Learn coil resistance, ideal wattage per ohm, sub-ohm vaping and MTL vs DTL, so you pick the right coil and e-liquid.
Read the guide